Configuring the ECN330-switch
1851553-KDU 137 365 Uen D 2006-06-16
Web – Click Port, Port Information or Trunk Information.
Figure 68 Port - Port Information
Field Attributes (CLI)
Basic information:
• Port type – Indicates the port type. (100BASE-TX, 1000BASE-T, or
SFP)
• MAC address – The physical layer address for this port. (To access this
item on the web, see “Setting the ECN330-switch’s IP Address” on
page 80.)
Configuration:
• Name – Interface label.
• Port Admin – Shows if the interface is enabled or disabled (that is, up
or down).
• Speed-duplex – Shows the current speed and duplex mode. (Auto, or
fixed choice)
• Capabilities – Specifies the capabilities to be advertised for a port
during auto-negotiation. (To access this item on the web, see
“Configuring Interface Connections” on page 3-48.) The following
capabilities are supported.
• 10half - Supports 10 Mbps half-duplex operation
• 10full - Supports 10 Mbps full-duplex operation
• 100half - Supports 100 Mbps half-duplex operation
To Next Page
Loading...
