Configuring the ECN330-switch
186 1553-KDU 137 365 Uen D 2006-06-16
• 100full - Supports 100 Mbps full-duplex operation
• 1000full - Supports 1000 Mbps full-duplex operation
• Sym - Transmits and receives pause frames for flow control
• FC - Supports flow control
• Broadcast Storm – Shows if broadcast storm control is enabled or
disabled.
• Broadcast Storm Limit – Shows the broadcast storm threshold. (500 -
262143 packets per second)
• Flow Control – Shows if flow control is enabled or disabled.
• LACP – Shows if LACP is enabled or disabled.
• Port Security – Shows if port security is enabled or disabled.
• Max MAC Count – Shows the maximum number of MAC address that
can be learned by a port. (0 - 1024 addresses)
• Port Security Action – Shows the response to take when a security
violation is detected. (shutdown, trap, trap-and-shutdown)
• Port MAC Learning – Shows whether or not MAC address learning is
enabled on this interface.
• Media Type – Shows the forced or preferred port type to use for
combination ports
25-26. (copper forced, SFP forced, SFP preferred
auto)
Current status:
• Link Status – Indicates if the link is up or down.
• Port Operation Status – Provides detailed information on port state.
(Displayed only when the link is up.).
• Operation Speed-Duplex – Shows the current speed and duplex
mode.
• Flow Control Type – Indicates the type of flow control currently in use.
(IEEE 802.3x, Back-Pressure or none)
To Next Page
Loading...
