Command Line Interface
10371553-KDU 137 365 Uen D 2006-06-16
7.26.7 router rip
This command enables Routing Information Protocol (RIP) routing for all IP
interfaces on the router except the defined management IP interface. Use the no
form to disable it.
Syntax
[no] router rip
Command Mode
Global Configuration
Default Setting
Disabled
Command Usage
• RIP is used to specify how routers exchange routing table information.
• This command is also used to enter router configuration mode.
Example
Related Commands
network (section 7.26.9 on page 1039)
Console(config)#router rip
Console(config-router)#
To Next Page
Loading...
