Command Line Interface
10451553-KDU 137 365 Uen D 2006-06-16
Default Setting
The default depends on the setting specified with the version command:
Global RIPv1 - Route information is broadcast to other routers with RIPv2
Global RIPv2 - RIPv2 packets
Command Usage
• Use this command to override the global setting specified by the RIP
version command.
• The receive version can be specified based on these options:
•Use none to passively monitor route information advertised by
other routers attached to the network.
•Use 1 or 2 if all routers in the local network are based on RIPv1 or
RIPv2, respectively.
•Use v2-broadcast to propagate route information by
broadcasting to other routers on the network using RIPv2, instead
of multicasting as normally required by RIPv2. (Using this mode
allows RIPv1 routers to receive these protocol messages, but still
allows RIPv2 routers to receive the additional information provided
by RIPv2, including subnet mask, next hop and authentication
information.)
Example
This example sets the interface version for VLAN 1 to send RIPv1 packets.
Related Commands
version (section 7.26.11 on page 1041)
Console(config)#interface vlan 1
Console(config-if)#ip rip send version 1
Console(config-if)#
To Next Page
Loading...
