Command Line Interface
10531553-KDU 137 365 Uen D 2006-06-16
Open Shortest Path First (OSPF)
This section describes commands used to configure OSPF global and interface
parameters for dynamic routing on the ECN330-switch.
Table 132 Open Shortest Path First Commands
Command Function Mode Page
General Configuration
router ospf Enables or disables OSPF GC 1055
router-id Sets the router ID for this device RC 1056
compatible
rfc1583
Calculates summary route costs using RFC 1583
(OSPFv1)
RC 1057
default-
information
originate
Generates a default external route into an
autonomous system
RC 1058
timers spf Configures the hold time between consecutive SPF
calculations
RC 1060
Route Metrics and Summaries
area range Summarizes routes advertised by an ABR RC 1061
area default-
cost
Sets the cost for a default summary route sent into a
stub or NSSA
RC 1062
summary-
address
Summarizes routes advertised by an ASBR RC 1063
redistribute Redistribute routes from one routing domain to
another
RC 1064
Area Configuration
network area Assigns specified interface to an area RC 1066
To Next Page
Loading...
