Command Line Interface
1056 1553-KDU 137 365 Uen D 2006-06-16
Default Setting
Disabled
Command Usage
• OSPF is used to specify how routers exchange routing table
information.
• This command is also used to enter router configuration mode.
Example
Related Commands
network area (section 7.26.28 on page 1066)
7.26.20 router-id
This command assigns a unique router ID for this device within the autonomous
system. Use the no form to use the default router identification method (that is,
the lowest interface address).
Syntax
router-id <ip-address>
no router-id
ip-address - Router ID formatted as an IP address.
Command Mode
Router Configuration
Console(config)#router ospf
Console(config-router)#
To Next Page
Loading...
