Command Line Interface
1126 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
Hello messages are sent to neighboring PIM routers from which this device
has received probes, and are used to verify whether or not these neighbors
are still active members of the multicast tree.
Example
7.27.20 ip pim hello-holdtime
This command configures the interval to wait for hello messages from a
neighboring PIM router before declaring it dead. Use the no form to restore the
default value.
Syntax
ip pim hello-holdtime <seconds>
no ip pim hello-holdtime
seconds - The hold time for PIM hello messages. (Range: 1-65535)
Default Setting
105 seconds
Command Mode
Interface Configuration (VLAN)
Command Usage
The ip pim hello-holdtime should be 3.5 times the value of ip pim
hello-interval (section 7.27.19 on page 1125).
Console(config-if)#ip pim hello-interval 60
Console(config-if)#
To Next Page
Loading...
