Command Line Interface
1162 1553-KDU 137 365 Uen D 2006-06-16
Register-
Rate-Limit
The rate at which register messages are sent by the
Designated Router (DR) for each (source, group) entry
Register-
CheckSum-
with Data
Shows if the register checksum is calculated over the
whole packet instead of just the packet header
Ignore RP-
Set-Priority
Shows if the priority value for RP candidates is ignored,
and only the hashing mechanism is used for RP selection
CRP-Prefix Shows if this router can be accepted as an RP candidate
by a Cisco BSR
SPT-
Threshold
Shows if the last-hop PIM-SM router is prevented from
switching to Shortest Path Tree (SPT) mode
Field Description
To Next Page
Loading...
