Upgrading Firmware
1168 1553-KDU 137 365 Uen D 2006-06-16
Figure 239 File Download Menu
6. Press <C> to change the baud rate of the ECN330’s serial connection.
Screen text displays as shown in Figure 240.
Figure 240 Changing the Baud Rate
7. Press <B> to select the option for 115200 baud.
There are two baud rate settings available, 9600 and 115200. Using the
higher baud rate minimizes the time required to download firmware code
files.
8. Set the PC’s terminal emulation software to match the 115200 baud rate.
Press <Enter> to reset communications with the ECN330-switch.
9. Check that the ECN330-switch has sufficient flash memory space for the
new code file before starting the download. From the CLI, use the dir
command to see how much available flash memory remains. The ECN330-
switch has a total of 32 Mbytes of flash memory for system files.
Image Loader 2.1.0.0
Password : *******
File Name S/Up Type Size Create Time
--------------------------------- ---- ---- ---------- -----------
$logfile_1 0 3 64 1193046:28:15
$logfile_2 0 3 64 1193046:28:15
ECN330-Diag_V2.0.6.1.bix 1 1 810688 00:02:25
ECN330_V1_0_2_21.bix 1 2 2937880 00:07:27
Factory_Default_Config.cfg 1 5 2385 00:00:25
certificate 0 8 31744 00:00:23
--------------------------------- ---- ---- ---------- ----------
Free Space : 8781824
[X]modem Download [D]elete File [S]et Startup File
[C]hange Baudrate [Q]uit
Select>
Select>
Change baudrate [A]9600 [B]115200
Baudrate set to 115200
To Next Page
Loading...
