Configuring the ECN330-switch
1551553-KDU 137 365 Uen D 2006-06-16
• An individual address cannot be deleted from a specified range. The
entire range must be deleted and the addresses reentered.
• An address range can be deleted just by specifying the start address, or
by specifying both the start address and end address.
Command Attributes
• Web IP Filter – Configures IP address(es) for the web group.
• SNMP IP Filter – Configures IP address(es) for the SNMP group.
• Telnet IP Filter – Configures IP address(es) for the Telnet group.
• IP Filter List – IP address which are allowed management access to
this interface.
• Start IP Address – A single IP address, or the starting address of a
range.
• End IP Address – The end address of a range.
Web – Click Security, IP Filter. Enter the addresses that are allowed
management access to an interface, and click Add IP Filtering Entry.
Figure 54 IP Filter
To Next Page
Loading...
