Configuring the ECN330-switch
170 1553-KDU 137 365 Uen D 2006-06-16
6.6.2.3 Configuring a MAC ACL Mask
This mask defines the fields to check in the packet header.
Command Usage
A mask must be configured for an ACL rule before it can be bound to a port.
Command Attributes
• Source/Destination Address Type – Use “Any” to match any address,
“Host” to specify the host address for a single node, or “MAC” to specify
a range of addresses. (Options: Any, Host, MAC; Default: Any)
• Source/Destination Bitmask – Address of rule must match this
bitmask.
• VID Bitmask – VLAN ID of rule must match this bitmask.
• Ethernet Type Bitmask – Ethernet type of rule must match this
bitmask.
• Packet Format Mask – A packet format must be specified in the rule.
To Next Page
Loading...
