Maintenance
191553-KDU 137 365 Uen D 2006-06-16
Caution!
The new Fan tray must be inserted immediately after the old one is removed.
4. Install a new fan tray in the ECN330 by sliding it back into the empty slot.
Push in firmly so that the fan tray's connector is fully engaged with the
ECN330.
5. Screw and tighten the fan tray's screw.
6. Check that the FAN status LED on the ECN330 front panel is off and that
both new fans are running.
7. Replace the fan tray access cover on the ECN330 front panel by pushing the
cover's right edge in until it snaps into place.
To Next Page
Loading...
