Ericsson ECN330 - Page 354

Configuring the ECN330-switch
348 1553-KDU 137 365 Uen D 2006-06-16
• Meter – The maximum throughput and burst rate.
• Rate (kbps) – Rate in kilobits per second.
• Burst (byte) – Burst in bytes.
• Exceed Action – Specifies whether the traffic that exceeds the
specified rate will be dropped or the DSCP service level will be reduced.
• Remove Class – Deletes a class.
- Policy Options -
• Class Name – Name of class map.
• Action – Configures the service provided to ingress traffic by setting a
CoS, DSCP, or IP Precedence value in a matching packet (as specified
in Match Class Settings on page 343). (Range - CoS: 0-7, DSCP: 0-63,
IP Precedence: 0-7)
• Meter – Check this to define the maximum throughput, burst rate, and
the action that results from a policy violation.
• Rate (kbps) – Rate in kilobits per second. (Range: 1-100000 kbps
or maximum port speed, whichever is lower)
• Burst (byte) – Burst in bytes. (Range: 64-1522)
• Exceed – Specifies whether the traffic that exceeds the specified rate
or burst will be dropped or the DSCP service level will be reduced.
• Set – Decreases DSCP priority for out of conformance traffic.
(Range: 0-63).
• Drop – Drops out of conformance traffic.
• Add – Adds the specified criteria to the policy map.