Configuring the ECN330-switch
3671553-KDU 137 365 Uen D 2006-06-16
Web – Click IP, IGMP, Interface Settings. Specify each interface that will support
IGMP (Layer 3), specify the IGMP parameters for each interface, then click
Apply.
Figure 152 IGMP Interface Settings
CLI – This example configures the IGMP parameters for VLAN 1.
Console(config)#interface vlan 1
Console(config-if)#ip igmp
Console(config-if)#ip igmp last-memb-query-interval 10
Console(config-if)#ip igmp max-resp-interval 20
Console(config-if)#ip igmp query-interval 100
Console(config-if)#ip igmp robustval 3
Console(config-if)#ip igmp version 1
Console(config-if)#end
Console#show ip igmp interface vlan 1
Vlan 1 is up
IGMP is enable, version is 2
Robustness variable is 2
Query interval is 125 sec
Query Max Response Time is 10 sec, Last Member Query Interval is 1 sec
Querier is 10.1.0.253
Console#
To Next Page
Loading...
