Initial Configuration
371553-KDU 137 365 Uen D 2006-06-16
The ECN330-switch’s HTTP web agent allows switch parameters to be
configured, port connections monitored, and statistics displayed using a
standard web browser such as Netscape Navigator version 6.2 and higher or
Microsoft IE version 5.0 and higher. The ECN330-switch’s web management
interface can be accessed from any computer attached to the network.
The CLI program can be accessed by a direct connection to the RS-232 serial
console port on the ECN330-switch, or remotely by a Telnet or Secure Shell
(SSH) connection over the network.
The ECN330-switch’s CLI configuration program and SNMP agent enable the
following management functions to be performed:
• Set user names and passwords
• Set an IP interface for any VLAN
• Configure SNMP parameters
• Enable or disable any port
• Set the speed and duplex mode for any port
• Configure the bandwidth of any port by limiting input or output rates
• Control port access through IEEE 802.1X security or static address
filtering
• Filter packets using Access Control Lists (ACLs)
• Configure up to 4094 IEEE 802.1Q VLANs
• Enable GVRP automatic VLAN registration
• Configure IP routing for unicast or multicast traffic
• Configure router redundancy
• Configure IGMP multicast filtering
• Upload and download system firmware through TFTP
• Upload and download ECN330-switch configuration files through TFTP
• Configure Spanning Tree parameters
• Configure Class of Service (CoS) priority queuing
• Configure up to 13 static or LACP trunks
To Next Page
Loading...
