Configuring the ECN330-switch
4331553-KDU 137 365 Uen D 2006-06-16
CLI - This example sets the receive version to accept both RIPv1 or RIPv2
messages, the send mode to RIPv1 compatible (that is, called v2-broadcast in
the
CLI), sets the method of preventing instability in the network topology to Split
Horizon,
enables authentication through a simple password (that is, called text
mode in the CLI).
6.20.9.4 Displaying RIP Information and Statistics
The ECN330-switch can display basic information about the current global
configuration settings for RIP, statistics about route changes and queries,
information about the interfaces that are using RIP, and information about known
RIP peer devices.
Table 28 RIP Information and Statistics
Console(config)#interface vlan 1
Console(config-if)#ip rip receive version 1 2
Console(config-if)#ip rip send version v2-broadcast
Console(config-if)#ip split-horizon
Console(config-if)#ip rip authentication mode text
Console(config-if)#ip rip authentication key mighty
Console#
Parameter Description
Globals
RIP Routing
Process
Indicates if RIP has been enabled or disabled.
Update Time in
Seconds
The interval at which RIP advertises known route
information. (Default: 30 seconds)
Number of Route
Changes
Number of times routing information has changed.
Number of
Queries
Number of router database queries received by this
router.
To Next Page
Loading...
