Configuring the ECN330-switch
4931553-KDU 137 365 Uen D 2006-06-16
Web – Click Routing Protocol, PIM-SM, General Settings. Enable or disable
PIM-SM globally for the router, and click Apply.
Figure 228 Enabling PIM-SM Globally
CLI – This example enables PIM-SM globally and displays the current status.
6.21.5.2 Configuring Global PIM-SM Settings
PIM-SM uses global settings to determine the method used in selecting
Rendezvous Point (RP) candidates. Timers for join/prune messages, register
messages, and register suppression also need to be configured on each of the
PIM-SM routers within the common multicast domain. Use of the Shortest Path
Tree (SPT) can also be disabled for specified multicast groups.
Command Attributes
• Ignore RP Set Priority – Ignores the priority value for RP candidates,
and only uses the hashing mechanism for RP selection.
(Default: Disabled)
• CRP Prefix – Allows the ECN330-switch to be accepted as an RP
candidate by a Cisco BSR. (Default: Disabled)
• Register Checksum With Data – Calculates the register checksum
over the whole packet instead of just the packet header.
(Default: Disabled)
• J/P Interval – Sets the join/prune interval. (Range: 1-65535 seconds;
Default: 60 seconds)
Console(config)#router pim sparse-mode
Console#show router pim
PIM Dense-Mode Admin Status: Disabled
PIM Sparse-Mode Admin Status: Enabled
Console#
To Next Page
Loading...
