Configuring the ECN330-switch
4991553-KDU 137 365 Uen D 2006-06-16
Web – Click Routing Protocol, PIM-SM, Interface Settings. Modify any of the
protocol parameters as required, and click Apply.
Figure 230 PIM-SM Interface Settings
CLI – This example sets the PIM-SM parameters for VLAN 1.
6.21.5.4 Configuring a Static Rendezvous Point
A static address can be set for the Rendezvous Point (RP) for a particular
multicast group.
Command Usage
• The specified router will act as an RP for all multicast groups in the local
PIM-SM domain if no group address is specified, or for the specified
group or group range (indicated by the mask).
• All routers within the same PIM-SM domain must be configured with the
same RP(s). Selecting an RP through the dynamic election process is
therefore preferable for most situations. Using the dynamic RP election
process also allows a backup RP to automatically take over if the active
RP router becomes unavailable.
Console(config)#interface vlan 1
Console(config-if)#ip pim sparse-mode
Console(config-if)#ip pim hello-interval 40
Console(config-if)#ip pim hello-holdtime 120
Console(config-if)#ip pim dr-priority 20
Console(config-if)#
To Next Page
Loading...
