Command Line Interface
5171553-KDU 137 365 Uen D 2006-06-16
2. At the prompt, enter the user name and system password. The CLI will
display the Vty-n# prompt for an administrator to show that it is in
privileged access mode (that is, Privileged Exec), or Vty-n> for a guest to
show that it is in normal access mode (that is, Normal Exec), where n
indicates the number of the current Telnet session.
3. Enter the necessary commands to complete the desired tasks.
4. When finished, exit the session with the quit or exit command.
After entering the Telnet command, the login screen displays:
Note: Up to four sessions can be opened to the device through Telnet.
Username: admin
Password:
CLI session with the Embedded Switching/Routing Unit is opened.
To end the CLI session, enter [Exit].
Vty-0#
To Next Page
Loading...
