Command Line Interface
546 1553-KDU 137 365 Uen D 2006-06-16
Command Usage
• Use this command in conjunction with the show startup-config
command to compare the information in running memory to the
information stored in non-volatile memory.
• This command displays settings for key command modes. Each mode
group is separated by ! symbols, and includes the configuration mode
command, and corresponding commands. This command displays the
following information:
• MAC address for the ECN330-switch
• SNTP server settings
• Queue mode
• SNMP community strings
• Users (names, access levels, and encrypted passwords)
• VLAN database (VLAN ID, name and state)
• VLAN configuration settings for each interface
• Multiple spanning tree instances (name and interfaces)
• IP address configured for VLANs
• Layer 4 precedence settings
• Routing protocol configuration settings
• Spanning tree settings
• Any configured settings for the console port and Telnet
To Next Page
Loading...
