Command Line Interface
598 1553-KDU 137 365 Uen D 2006-06-16
7.5.43 logging sendmail destination-email
This command specifies the email recipients of alert messages. Use the no form
to remove a recipient.
Syntax
[no] logging sendmail destination-email <email-address>
email-address - The source email address used in alert messages.
(Range: 1-41 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
Up to five recipients can specified for alert messages. However, a separate
command must be entered to specify each recipient.
Example
Console(config)#logging sendmail destination-email ted@this-
company.com
Console(config)#
To Next Page
Loading...
