Command Line Interface
670 1553-KDU 137 365 Uen D 2006-06-16
Table 64 Port Security Commands
7.7.31 port security
This command enables or configures port security. Use the no form without any
keywords to disable port security. Use the no form with the appropriate keyword
to restore the default settings for a response to security violation or for the
maximum number of allowed addresses.
Syntax
port security [action {shutdown | trap | trap-and-
shutdown} | max-mac-count <address-count>]
no port security [action | max-mac-count]
• action - Response to take when port security is violated.
• shutdown - Disable port only.
• trap - Issue SNMP trap message only.
• trap-and-shutdown - Issue SNMP trap message and
disable port.
• max-mac-count
• address-count - The maximum number of MAC addresses
that can be learned on a port. (Range: 0 - 1024, where 0 means
disabled)
Command Function Mode Page
port security Configures a secure port IC 670
mac-address-table static Maps a static address to a port in a VLAN GC 787
show mac-address-table Displays entries in the bridge-forwarding
database
PE 789
mac-learning Enables MAC address learning on the selected
port
IC 672
show mac-learning Displays the status of MAC address learning
status for all ports.
PE 673
To Next Page
Loading...
