Command Line Interface
692 1553-KDU 137 365 Uen D 2006-06-16
7.8.1 access-list ip
This command adds an IP access list and enters configuration mode for
standard or extended IP ACLs. Use the no form to remove the specified ACL.
Syntax
[no] access-list ip {standard | extended} <acl_name>
• standard – Specifies an ACL that filters packets based on the
source IP address.
• extended – Specifies an ACL that filters packets based on the
source or destination IP address, and other more specific criteria.
• acl_name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
• An egress ACL must contain all deny rules.
• When a new ACL is created or configuration mode entered for an
existing ACL, use the permit or deny command to add new rules to
the bottom of the list. To create an ACL, add at least one rule to the list.
• To remove a rule, use the no permit or no deny command followed
by the exact text of a previously configured rule.
• An ACL can contain up to 32 rules.
Example
Console(config)#access-list ip standard david
Console(config-std-acl)#
To Next Page
Loading...
