Command Line Interface
698 1553-KDU 137 365 Uen D 2006-06-16
Example
Related Commands
permit, deny (section 7.8.2 on page 693)
ip access-group (section 7.8.8 on page 705)
7.8.5 access-list ip mask-precedence
This command changes to the IP Mask mode used to configure access control
masks. Use the no form to delete the mask table.
Syntax
[no] access-list ip mask-precedence {in | out}
• in – Ingress mask for ingress ACLs.
• out – Egress mask for egress ACLs.
Default Setting
Default system mask: Filter inbound packets according to specified IP ACLs.
Command Mode
Global Configuration
Command Usage
• A mask can only be used by all ingress ACLs or all egress ACLs.
• The precedence of the ACL rules applied to a packet is not determined
by order of the rules, but instead by the order of the masks; that is, the
Console#show ip access-list standard
IP standard access-list david:
permit host 10.1.1.21
permit 168.92.0.0 255.255.15.0
Console#
To Next Page
Loading...
