Command Line Interface
710 1553-KDU 137 365 Uen D 2006-06-16
[no] {permit | deny} tagged-802.3
{any | host <source> | <source> <address-bitmask>}
{any | host <destination> | <destination> <address-
bitmask>}
[vid <vid> <vid-bitmask>]
[no] {permit | deny} untagged-802.3
{any | host <source> | <source> <address-bitmask>}
{any | host <destination> | <destination> <address-
bitmask>}
• tagged-eth2 – Tagged Ethernet II packets.
• untagged-eth2 – Untagged Ethernet II packets.
• tagged-802.3 – Tagged Ethernet 802.3 packets.
• untagged-802.3 – Untagged Ethernet 802.3 packets.
• any – Any MAC source or destination address.
• host – A specific MAC address.
• source – Source MAC address.
• destination – Destination MAC address range with bitmask.
• address-bitmask – Bitmask for MAC address (in hexadecimal
format).
• vid – VLAN ID. (Range: 1-4094)
• vid-bitmask
–
VLAN bitmask. (Range: 1-4094)
• protocol – A specific Ethernet protocol number. (Range: 600-fff
hex.)
• protocol-bitmask – Protocol bitmask. (Range: 600-fff hex.)
Note: For all bitmasks, “1” means care and “0” means ignore.
Default Setting
None
Command Mode
MAC ACL
To Next Page
Loading...
