Ericsson ECN330 - Page 760

Command Line Interface
754 1553-KDU 137 365 Uen D 2006-06-16
Example
This example shows the configuration setting for port 3.
Table 73 Interface Parameters
Console#show interfaces switchport ethernet 1/3
Broadcast threshold: Enabled, 500 packets/second
LACP status: Disabled
Ingress rate limit: disable,1000M bits per second
Egress rate limit: disable,1000M bits per second
VLAN membership mode: Hybrid
Ingress rule: Disabled
Acceptable frame type: All frames
Native VLAN: 1
Priority for untagged traffic: 0
Gvrp status: Disabled
Allowed Vlan: 1(u),
Forbidden Vlan:
Private-VLAN Mode: NONE
Private-VLAN host-association: NONE
Private-VLAN Mapping: NONE
Console#
Field Description
Broadcast
threshold
Shows if broadcast storm suppression is enabled or
disabled; if enabled it also shows the threshold level
(section 7.9.9 on page 747).
Lacp status Shows if Link Aggregation Control Protocol has been
enabled or disabled (section 7.10.2 on page 759).
Ingress/Egress
rate limit
Shows if rate limiting is enabled or disabled, and the
current rate limit (section 7.12 on page 776).
VLAN
membership
mode
Indicates membership mode as Trunk or Hybrid
(section 7.17.6 on page 857).
Ingress rule Shows if ingress filtering is enabled or disabled
(section 7.17.8 on page 859).