Command Line Interface
758 1553-KDU 137 365 Uen D 2006-06-16
• If the port channel admin key (lacp admin key - Port Channel) is not set
when a channel group is formed (that is, it has the null value of 0), this
key is set to the same value as the port admin key (lacp admin key -
Ethernet Interface) used by the interfaces that joined the group.
• However, if the port channel admin key is set, then the port admin key
must be set to the same value for a port to be allowed to join a channel
group.
• If a link goes down, LACP port priority is used to select the backup link.
7.10.1 channel-group
This command adds a port to a trunk. Use the no form to remove a port from a
trunk.
Syntax
channel-group <channel-id>
no channel-group
channel-id - Trunk index (Range: 1-13)
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
• When configuring static trunks, the switches must comply with the Cisco
EtherChannel standard.
•Use no channel-group to remove a port group from a trunk.
•Use no interfaces port-channel to remove a trunk from the
ECN330-switch.
To Next Page
Loading...
