Command Line Interface
7631553-KDU 137 365 Uen D 2006-06-16
this key is set to the same value as the port admin key (lacp admin
key - Ethernet Interface) used by the interfaces that joined the group.
• Once the remote side of a link has been established, LACP operational
settings are already in use on that side. Configuring LACP settings for
the partner only applies to its administrative state, not its operational
state, and will only take effect the next time an aggregate link is
established with the partner.
Example
7.10.5 lacp admin-key (Port Channel)
This command configures a port channel's LACP administration key string. Use
the no form to restore the default setting.
Syntax
lacp admin-key <key>
[no] lacp admin-key
key - The port channel admin key is used to identify a specific link
aggregation group (LAG) during local LACP setup on the ECN330-
switch. (Range: 0-65535)
Default Setting
0
Command Mode
Interface Configuration (Port Channel)
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor admin-key 120
Console(config-if)#
To Next Page
Loading...
