Command Line Interface
7651553-KDU 137 365 Uen D 2006-06-16
Command Mode
Interface Configuration (Ethernet)
Command Usage
• Setting a lower value indicates a higher effective priority.
• If an active port link goes down, the backup port with the highest priority
is selected to replace the downed link. However, if two or more ports
have the same LACP port priority, the port with the lowest physical port
number will be selected as the backup port.
• Once the remote side of a link has been established, LACP operational
settings are already in use on that side. Configuring LACP settings for
the partner only applies to its administrative state, not its operational
state, and will only take effect the next time an aggregate link is
established with the partner.
Example
Console(config)#interface ethernet 1/5
Console(config-if)#lacp actor port-priority 128
To Next Page
Loading...
