Configuring the ECN330-switch
751553-KDU 137 365 Uen D 2006-06-16
Command Attributes
• SBC – Enables or disables the SBC. (Default: ON)
Web – Click System, SBC. Enable or disable the SBC, and click Apply.
Figure 12 System SBC Status
CLI – This example enables the SBC.
6.3.5 Displaying ECN330-switch Hardware/Software Versions
Use the Switch Information page to display hardware/firmware version numbers
for the main board and management software, as well as the power status of the
system.
Field Attributes
Main Board
• Serial Number – The serial number of the ECN330-switch.
• Number of Ports – Number of built-in ports.
• Hardware Version – Hardware version of the main board.
• Main Power Status – Displays the status of the internal power supply.
Console(config)#sbc power
System will switch to ECN330 mode, continue <y/n>? y
FS_STORAGE_Write::Begin writing to the protected area!!
FS_STORAGE_Write::Writing to the protected area completed.
To Next Page
Loading...
