Command Line Interface
8491553-KDU 137 365 Uen D 2006-06-16
7.17.2 vlan database
This command enters VLAN database mode. All commands in this mode will
take effect immediately.
Default Setting
None
Command Mode
Global Configuration
Command Usage
• Use the VLAN database command mode to add, modify, and delete
VLANs. After finishing configuration changes, the VLAN settings can be
displayed by entering the show vlan command.
• Use the interface vlan command mode to define the port
membership mode and add or remove ports from a VLAN. The results
of these commands are written to the running-configuration file, and this
file can be displayed by entering the show running-config
command.
Example
Related Commands
show vlan (section 7.17.13 on page 866)
Console(config)#vlan database
Console(config-vlan)#
To Next Page
Loading...
