Command Line Interface
8791553-KDU 137 365 Uen D 2006-06-16
Command Mode
Global Configuration
Example
The following creates protocol group 1, and specifies Ethernet frames with IP
and ARP protocol types:
7.17.23 protocol-vlan protocol-group (Configuring Interfaces)
This command maps a protocol group to a VLAN for the current interface. Use
the no form to remove the protocol mapping for this interface.
Syntax
protocol-vlan protocol-group <group-id> vlan <vlan-id>
no protocol-vlan protocol-group <group-id> vlan
• group-id - Group identifier of this protocol group. (Range: 1-
2147483647)
• vlan-id - VLAN to which matching protocol traffic is forwarded.
(Range: 1-4094)
Default Setting
No protocol groups are mapped for any interface.
Command Mode
Interface Configuration (Ethernet, Port Channel)
Console(config)#protocol-vlan protocol-group 1 add frame-type
ethernet protocol-type ip
Console(config)#protocol-vlan protocol-group 1 add frame-type
ethernet protocol-type arp
Console(config)#
To Next Page
Loading...
