Command Line Interface
898 1553-KDU 137 365 Uen D 2006-06-16
7.19.1 queue mode
This command sets the queue mode used the class of service (CoS) priority
queues. The options include strict priority, Weighted Fair Queueing (WFQ),
Weighted Round-Robin (WRR), or a combination of strict and weighted
queueing. Use the no form to restore the default value.
Syntax
queue mode {strict | wfq | wrr | strict-wfq <sp-queue> |
strict-wrr <sp-queue>}
no queue mode
• strict - Services the egress queues in sequential order,
transmitting all traffic in the higher priority queues before servicing
lower priority queues. This ensures that the highest priority packets
are always serviced first, ahead of all other traffic.
queue min-
bandwidth
Assigns fair queueing minimum bandwidth to the
priority queues
IC 903
queue cos map Assigns class of service values to the priority
queues
IC 904
show queue mode Shows the current queue mode PE 906
show queue
bandwidth
Shows round-robin weights assigned to the priority
queues
PE 906
show queue min-
bandwidth
Shows fair queueing minimum bandwidth assigned
to the priority queues
PE 907
show queue cos-
map
Shows the class of service map PE 908
show interfaces
switchport
Displays the administrative and operational status
of an interface
PE 753
Command Function Mode Page
To Next Page
Loading...
