Ericsson ECN330 - Page 948

Command Line Interface
942 1553-KDU 137 365 Uen D 2006-06-16
Example
The following shows the multicast entries learned through IGMP snooping for
VLAN 1:
IGMP Query Commands (Layer 2)
This section describes commands used to configure Layer 2 IGMP query on the
ECN330-switch.
Table 108 IGMP Query Commands (Layer 2)
Console#show mac-address-table multicast vlan 1 igmp-snooping
VLAN M'cast IP addr. Member ports Type
---- --------------- ------------ -------
1 224.1.2.3 Eth1/11 IGMP
Console#
Command Function Mode Page
ip igmp snooping
querier
Allows the ECN330-switch to act as the querier
for IGMP snooping
GC 943
ip igmp snooping
query-count
Configures the query count GC 944
ip igmp snooping
query-interval
Configures the query interval GC 945
ip igmp snooping
query-max-
response-time
Configures the report delay GC 946
ip igmp snooping
report-
suppression
Suppresses requirement for hosts to respond to
queries
GC
ip igmp snooping
router-port-
expire-timet
Configures the query timeout GC 948