Ericsson ECN330 - Page 958

Command Line Interface
952 1553-KDU 137 365 Uen D 2006-06-16
Example
The following shows the ports in VLAN 1 which are attached to multicast routers:
IGMP Commands (Layer 3)
This section describes commands used to configure Layer 3 IGMP on the
ECN330-switch.
Table 110 IGMP Commands (Layer 3)
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/11 Static
2 Eth 1/12 Dynamic
Console#
Command Function Mode Page
ip igmp Enables IGMP for the specified interface IC 953
ip igmp robustval Configures the expected packet loss IC 954
ip igmp query-
interval
Configures frequency for sending host query
messages
IC 955
ip igmp max-resp-
interval
Configures the maximum host response time IC 956
ip igmp last-
memb-query-
interval
Configures frequency for sending group-specific
host query messages
IC 957
ip igmp version Configures IGMP version used on this interface IC 958
show ip igmp
interface
Displays the IGMP configuration for specified
interfaces
NE, PE 959