Configuring the ECN330-switch
931553-KDU 137 365 Uen D 2006-06-16
• Stop Bits – Sets the number of the stop bits transmitted per byte.
(Range: 1-2; Default: 1 stop bit)
These parameters can only be configured in the CLI.
• Password – Specifies a password for the line connection. When a
connection is started on a line with password protection, the system
prompts for the password. If the correct password is entered, the system
shows a prompt. (Default: No password)
• Login – Enables password checking at login. Select authentication by
entering a single global password as configured for the Password
parameter, or by entering a password set up for a specific user-name
account. (Default: Local)
Web – Click System, Line, Console. Specify the console port connection
parameters as required, then click Apply.
Figure 24 Configuring the Console Port
To Next Page
Loading...
