133
8-4. Parameters That Are Not Stored in Event Memories
The following parameters are not stored in event memories.
DISABLE/ENABLE settings of CHANGEOVER in the VIDEO INPUT SET menu (5-7-1).
ON/OFF settings of FREEZE in the FREEZE SET menu (5-10-2).
ON/OFF settings of MASTER MUTE in the MASTER OUT GAIN Settings (MASTER) menu
(6-4).
All settings in the EVENT SETUP menu (8-3).
All settings in the Other Settings & Information (OTHER) menu (7).
All settings in the Various Signal Status Display (STATUS) menu (5-13).
Unit Name setting in the Event Control menu (9-6-1).
All settings in the Network Settings menu (9-8).
8-5. Note on Event Memory Operation
Do not power off the unit while saving an event. The event may not be properly stored.
Also, the FA-9500 regularly updates the setting data. Do not turn off the unit for at least 5
seconds after changing settings. It is recommended to save important data into a backup file.
See sections 9-6-2 “Backup Parameter” and 9-6-4 “Backup Event Data” for details on how to
save setting data into a backup file.
To Next Page
Loading...
