56
5-8. VIDEO OUT SELECT (OUT SEL)
Allows you to select output modes and whether to output a signal from CONV1 or CONV2 for
respective video output connectors.
IMPORTANT
If CONV DLY ADJ in section 5-10-4 “VIDEO SUB” is enabled, all outputs from SDI 1/2,
SDI 3/4, Composite, and Component will be adjusted to be the same delay.
If CONV DLY ADJ is disabled, the outputs in the same format with inputs will be
by-passed through without conversions.
5-8-1. SDI1/2 OUT SET
Allows you to assign video signals to output from video output connectors SDI1 and 2.
SDI1/2 OUT SET 72
ASSIGN:CONV1
525/60 >>1080/59i
Parameter Default
Setting range
(Steps)
Description
ASSIGN CONV1
CONV1
CONV2
Selects whether to output a signal of
CONV1 or CONV2 from SDI1 and 2
connectors.
－ － －
The input signal format and SDI1 and
2 output signal formats are displayed
on the third row.
5-8-2. SDI3/4 OUT SET
Allows you to assign video signals to output from video output connectors SDI3 and 4.
SDI3/4 OUT SET 73
ASSIGN:CONV1
525/60 >>1080/59i
Parameter Default Setting range Description
ASSIGN CONV1
CONV1
CONV2
Selects whether to output CONV1 or
CONV2 signal from the SDI3 and 4
connectors.
－ － －
The input signal format and SDI3 and 4
output signal formats are displayed on
the third row.
Menu button
OUT SEL
MODE
Menu button
OUT SEL
MODE
To Next Page
Loading...
