189
9-3-16. Dolby E Encoder
Clicking block (16) on the audio block diagram when the FA-95DE-E option is installed opens
the Dolby E Encoder dialog box.
After completing the settings, click Close to close the dialog box.
Click Refresh to update the settings.
Dolby Encoder Input Assign
Parameter Default Setting range Description
Input
Selection
Direct Input
Selection
Direct Input Selection
Dolby Decoder
Output
Selects a signal to be input to the Dolby
encoder.
*1
Direct Input Selection: Source channel
signals
Dolby Decoder Output: Output signal
from the Dolby decoder
*1
CH1-8 *2
When Direct Input
Selection is selected
Source1-16
PCM Down Mix-L
PCM Down Mix -R
500Hz TONE
1kHz TONE
Silence
When Dolby Decoder
Output is selected
Dolby Decoder 1-8
Dolby Down Mix-L
DolbyDown Mix-R
500Hz TONE
1kHz TONE
Siilence
When Input Selection is set to Direct Input
Selection:
Source1-16: SOURCE signal selected in
the 6-5 AUDIO MAPPING (MAPPING)
menu
PCM Down Mix-L/R: Down mixed signal
generated from SOURCE channel signals.
500Hz/1kHz TONE: Test signal (TONE)
Silence: Mute signal
When Input Selection is set to Dolby
Decoder Output:
Dolby Decoder1-8: PCM signal output from
the Dolby decoder
DolbyDown Mix-L/R: Down mixed signal
generated from Dolby-decoded PCM
signal
500Hz/1kHz TONE: Test signal (TONE)
Silence: Mute signal
*1 Direct Input Selection and Dolby Decoder Output settings are retained until changed.
When these Input Selection settings are switched, CH 1-8 assignments will be changed to
those of the Input Selection setting. Direct Input Selection and Dolby Decoder Output
signals cannot be input to the Dolby encoder together. Dolby Digital signal input to the
Dolby Decoder Output cannot be re-encoded to a Dolby E signal.
To Next Page
Loading...
