FOR-A FA-9500 - 3-4. To Embed Analog Audio Signals on SDI Signals

10
3-4. To Embed Analog Audio Signals on SDI Signals
The following describes how to embed a 4- channel analog audio signal on SDI OUT1 through 4
output signals.
Settings that need to be checked:
 Select SOURCE SEL 1/2 and set SOURCE SET to ANA1/2 as described in section 6-5-1
“SOURCE/SRC SEL”.
Also, select SOURCE SEL 3/4, and set SOURCE SET to ANA3/4.
NOTE
See section 12 "Analog Audio Connection” for the ANALOG AUDIO connector
connection.
Provide audio settings, if necessary, as described in section 6-3 “ANALOG AUDIO
Settings (ANALOG)”.
REMOTE
LAN1
COMPOSITE
OUT3OUT2IN1
SDI
ANALOG AUDIO
LAN2
IO1/2
DIGITAL AUDIO
OUT4OUT1 IN2
FAN2
IO3/4 IO5/6 IO7/8
GENLOCK IN
FAN1
OUT1 OUT2IN
Input an audio signal to
ANALOG AUDIO IN1 - 4
channels.
The Analog audio signals are
embedded to AUDIO CH 1 through 4 of
output signals from SDI OUT1 – 4.
Input an HD/SD-SDI
signal to SDI IN１.