53
5-7-11. SILENCE TRG
This menu is accessible only if the FA-95CO software option is installed.
SILENCE TRG 62
CH SEL :CH1
TRIGGER :DISABLE
CHGOV DISABLED
Parameter Default
Setting range
(Steps)
Description
CH SEL CH1 CH1 to 16
Selects an embedded audio channel for
which to set the trigger.
TRIGGER DISABLE
DISABLE
ENABLE
Enables or disables auto changeover
for audio silence in the embedded audio
channel.
* The “CHGOV DISABLED” message is displayed if CHANGEOVER is disabled in the
VIDEO INPUT SET (5-7-1) menu or VIDEO TRG is disabled in the CHGOV
(CHANGEOVER) MODE SET (5-7-4) menu. If this message is displayed, a changeover
will not be performed even though SILENCE TRG is enabled. The duration to determine
SDI embedded audio is silent depends on the duration set in the 6-10-4 DIGITAL
SILENCE menu.
5-7-12. CHGOV STATUS
This menu is accessible only if the FA-95CO software option is installed.
Settings in this menu will reset themselves whenever CHANGEOVER in the VIDEO INPUT
SET (5-7-1) menu has been set to DISABLE.
CHGOV STATUS 63
VIDEO:NON-TRG
AUDIO:NON-TRG
VIDEO IN:SDI1
CHGOV DISABLED
Parameter Description
VIDEO
Displays the status of video related triggers at the time a changeover is
performed.
DISABLE: Video-related triggers are disabled.
NON-TRG: No video-related trigger is activated.
TRIGGER: Changeover is performed due to (a) video-related trigger(s).
AUDIO
Displays the status of audio related triggers at the time a changeover is
performed.
DISABLE: Audio-related triggers are disabled.
NON-TRG: No audio-related trigger is activated.
TRIGGER: Changeover is performed due to (an) audio-related trigger(s).
VIDEO IN
Displays the current active input signal.
SDI1: The current active input is SDI1.
SDI1→SDI2: The input signal is changed over to SDI2 from SDI1.
SDI2: The current active input is SDI2.
Composite: The current input signal is composite video.
YPbPr SMPTE
*1
: The current input signal is component video. (SD-SDI
signals are SMPTE level signals.)
YPbPr BETA
*1
: The current input signal is component video. (SD-SDI
signals are BETACAM level signals.)
RGB
*1
: The current input signal is RGB video.
Y/C
*1
: The current input signal is Y/C video.
*1 Shown only if the FA-95AIO option is installed.
* The “CHGOV DISABLED” message is displayed if CHANGEOVER is disabled in the 5-7-1
VIDEO INPUT SET menu. If this message is displayed, a changeover will not be
performed.
Menu button
IN SEL
DOWNMIX
Menu button
IN SEL
DOWNMIX
To Next Page
Loading...
