FOR-A FA-9500 - Page 172

156
 Antialias
Parameter Default Setting range Description
Horizontal Normal
Weak 8-1
Normal
Strong 1-8
Performs horizontal anti-aliasing for the
output video image.
Weak 8 to Strong 8 (low to high)
This setting cannot be changed if the
conversion is set to the formats indicated as
(DOWN) in the CONV2 Conversion Table in
section 5-4-2.
Vertical Normal
Weak 8-1
Normal
Strong 1-8
Performs vertrical anti-aliasing for the output
video image.
Weak 8 to Strong 8 (low to high)
This setting cannot be changed if the
conversion is set to the formats indicated as
(DOWN) in the CONV2 Conversion Table in
section 5-4-2.
The Antialias setting cannot be changed if Converter2 Process Mode is set to BY-PASS, or if
the conversion is set to the formats indicated as (BY-PASS) in the CONV2 Conversion Table
(5-4-2).
 Enhance
Parameter Default
Setting range
(Steps)
Description
Enhance Level 0 Level 0-8
Sharpen the output video image.
Level 0 to 8 (low to high)
The Enhance setting cannot be changed if Converter2 Process Mode is set to BY-PASS. Also,
it cannot be changed if the conversion is set to the formats indicated as (BY-PASS) in the
CONV2 Conversion Table (5-4-2).
 Converter2 Size
Parameter Default
Setting range
(Steps)
Description
H Size
(Horizontal Size)
100.0％
50.0 - 150.0%
(0.1%)
Adjusts the width of the video
displayed on the monitor.
V Size
(Vertical Size)
100.0％
50.0 - 150.0%
(0.1%)
Adjusts the height of the video
displayed on the monitor.
The Converter2 Size setting cannot be changed if Converter2 Process Mode is set to
BY-PASS. Also, it cannot be changed if the conversion is set to the formats indicated as
(BY-PASS) in the CONV2 Conversion Table (5-4-2).
 Converter2 Position
Parameter Default
Setting range
(Steps)
Description
H Position
(Horizontal Position)
0 Pixel
Variable
*1
(2 Pixel)
Adjusts the horizontal position of
the video displayed on the monitor.
V Position
(Vertical Position)
0 Line
Variable
*1
(1 Line)
Adjusts the vertical position of the
video displayed on the monitor.
The Converter2 Position setting cannot be changed if Converter2 Process Mode is set to
BY-PASS. Also, it cannot be changed if the conversion is set to the formats indicated as
(BY-PASS) in the CONV2 Conversion Table (5-4-2).
*1 These Position setting ranges vary depending on the Converter2 Process Mode, and Sync
Format settings in FS Mode (9-4-1 Video System).