FOR-A FA-9500 - 9-6-4. Backup Event Data

197
 Converter1 Audio Group
Parameter Default Setting range Description
Group1 Enable
Disable
Enable
*2
Disable: Does not insert GROUP 1-embedded
audio.
Enable： Inserts GROUP 1-embedded audio.
Group 2 Enable
Disable
Enable
*2
Disable: Does not insert GROUP 2-embedded
audio.
Enable： Inserts GROUP 2-embedded audio.
Group 3 Enable
Disable
Enable
*2
Disable: Does not insert GROUP 3-embedded
audio.
Enable： Inserts GROUP 3-embedded audio.
Group 4
*1
Enable
Disable
Enable
*2
Disable: Does not insert GROUP 4-embedded
audio.
Enable： Inserts GROUP 4-embedded audio.
*1 GROUP4 embedded audio cannot be inserted into SD-SDI output signals regardless of the
GROUP4 setting.
*2 The setting is ineffective if the input and output formats are the same, and H ANC is set to In
Data under Converter1 Ancillary Setting.
 Converter2 Audio Group
Parameter Default Setting range Description
Group1 Enable
Disable
Enable
*2
Disable: Does not insert GROUP 1-embedded audio.
Enable： Inserts GROUP 1-embedded audio.
Group 2 Enable
Disable
Enable
*2
Disable: Does not insert GROUP 2-embedded audio.
Enable： Inserts GROUP 2-embedded audio.
Group 3 Enable
Disable
Enable
*2
Disable: Does not insert GROUP 3-embedded audio.
Enable： Inserts GROUP 3-embedded audio.
Group 4
*1
Enable
Disable
Enable
*2
Disable: Does not insert GROUP 4-embedded audio.
Enable： Inserts GROUP 4-embedded audio.
*1 GROUP4 embedded audio cannot be inserted into SD-SDI output signals regardless of the
GROUP4 setting.
*2 The setting is ineffective if the input and output formats are the same, and H ANC is set to In
Data under Converter2 Ancillary Setting.
 SD Line Mask
Parameter Default Setting range Description
Line6-23 Pass
Pass
Blank
Pass: Outputs the line to a composite, Y/C or SD-SDI
output signal without processing.
Blank: Masks the selected composite, Y/C or SD-SDI
output signal line.
 PAL-M Mode Set
Parameter Default Setting range Description
PAL-M
Mode Set
Disable
Disable
Enable
Disable: Allows NTSC signals to be output.
Enable: Allows PAL-M signals to be output.
*1
*1 This setting is effective on composite and Y/C outputs. NTSC and PAL signals can be input,
however, NTSC signal cannot be output. If this mode is enabled, GENLOCK IN recognizes
PAL-M signals as 525/60, however, NTSC BB signals become ineffective. (PAL BB signals
and tri-level sync signals can be used.)