Fujitsu 1FINITY L100 - Page 306

Enty Type Severity
Service
Aected
Direcon Locaon Descripon
1GEX warning non–service-
aecng
n/a NEND Mismatch of Equipment and Aributes:
TYPE=<unit type> and the admin-status is
down
Probable Cause Suggested Correcve Acon
■ The SFP module installed in the
specied port is mismounted.
■ The SFP module does not match the
port for which it is provisioned.
1. Remove and remount the SFP module.
2. Replace the SFP module with the correct SFP module.
1GEX minor non–service-
aecng
n/a NEND Mismatch of Equipment and Aributes:
TYPE=<unit type>
Probable Cause Suggested Correcve Acon
■ The SFP module installed in the
specied port is mismounted.
■ The SFP module does not match the
port for which it is provisioned.
1. Remove and remount the SFP module.
2. Replace the SFP module with the correct SFP module.
1GEX crical service-
aecng
n/a NEND Mismatch of Equipment and Aributes:
TYPE=<unit type>
Probable Cause Suggested Correcve Acon
■ The SFP module installed in the
specied port is mismounted and has an
interface provisioned on it.
■ The SFP module does not match the
port for which it is provisioned and has
an interface provisioned on it.
1. Remove and remount the SFP module.
2. Replace the SFP module with the correct SFP module.
100ME warning non–service-
aecng
n/a NEND Interblade communicaon Miscabled
Connecon: TYPE = <unit type>
Probable Cause Suggested Correcve Acon
■ The SFP module installed in the
specied port is mismounted.
■ The SFP module does not match the
port for which it is provisioned.
1. Remove and remount the SFP module.
2. Replace the SFP module with the correct SFP module.
System Maintenance
Trouble Clearing
306
Release 19.1.1 · Issue 1.1, May 2021
Fujitsu and Fujitsu Customer Use Only