GE Discovery LS - Figure 5-1: Locations of Console Components (H2 Shown); Figure 5-2: Key Console Components (H2 Shown)

GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Page 108 Chapter 5 - Console
Communications between the CT Host and SRU take place primarily using a network channel and
serial connections. Using the network channel allows sharing of resources on the CT Host disk by
the SRU (client). Serial communications are used for the downloading and “flashing” memory
(PROM) in the SRU when needed. Serial communications between the PET Workstation and the
CT Host are performed via a Null modem cable. For network communications, the PET Workstation
is connected into a fast ethernet switch located inside the Console.
The location of the cosole components are shown in Figure 5-1, key components in Figure 5-2, and
a connections diagram in Figure 5-3. These illustrations are for the H2, and may differ slightly for
the H3 and GOC1 consoles.
Figure 5-1: Locations of Console Components (H2 Shown)
Figure 5-2: Key Console Components (H2 Shown)
DAT Drive
CT
(optional)
MOD Drive
PET Computer
PET Computer
DAT Drive
(optional)
MOD Drive