GE Discovery LS - 6.5.2 Replacing the Secondary Base Front Pulley

GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Page 218 Chapter 6 - Table
2.) Refer to Figure 6-147. Loosen the four screws holding the timing belt clamp, and remove the
clamp with the belt.
Figure 6-147: Timing Belt Clamp
3.) Insert the new timing belt over the pulley and through the slot in the cam rollers block. (The
ends of the belt must be positioned as close as possible to each other to enable secure
clamping by the clamp teeth.)
4.) Place the clamp on the belt ends and secure with the four screws.
5.) Refer to Figure 6-146. Push the front pulley to tighten the timing belt, and fasten the four
screws in the slots.
6.5.2 Replacing the Secondary Base Front Pulley
1.) Refer to Figure 6-146. Loosen the four screws that hold the front pulley to release the timing
belt.
2.) Refer to Figure 6-147. Loosen the four screws holding the timing belt clamp, and remove the
clamp with the belt.
3.) Replace the pulley.
4.) Insert the new timing belt over the pulley and through the slot in the cam rollers block. (The
ends of the belt must be positioned as close as possible to each other to enable secure
clamping by clamp teeth.
5.) Place the clamp on the belt ends, and secure with the four screws.
6.) Refer to Figure 6-146. Push the front pulley to tighten the timing belt and fasten the four screws
in the slots.
Clamp Screws (4)
Belt Ends