GE Discovery LS - Install the Top Cover Brackets; Figure 6-108: Install Three Top Cover Brackets

GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Page 186 Chapter 6 - Table
6.2.6.40 Install the Top Cover Brackets
NOTICE Do NOT install the fourth cover bracket until the characterization bracket is installed.
1.) Refer to Figure 6-108. Use a 5 mm Allen wrench to fasten three of the four top cover brackets
to the ETC Assembly.
Figure 6-108: Install Three Top Cover Brackets
2.) Locate and remove the following hardware from the upgrade kit:
Part Number Description Quantity
2333042 Right Front Bracket 1
2333041 Left Front and Rear Brackets 2
46-328417P13 M6 x 16 mm Screw 6
2109878-3 M6 Flat Washer 6
2315373-4 M6 Lock Washer 6
Left Rear Bracket
Left Front Bracket
Right Front Bracket (P/N 233042)
(P/N 233041)
Fourth Top Cover Bracket
(Install after the Characterization Bracket.)
(P/N 233041)