GE Discovery LS - Tools Required; Direction 2307224-100, Revision Discovery Ls System Service Manual

GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Chapter 1 - Preface Page 35
1.4.2 Tools Required
Table 1-1 lists the tools recommended for the DLS installation, but not supplied by GE.
Table 1-1: : Recommended Installation Tools
Description Quantity
Standard Field Engineer’s Tool Kit 1
May need the additional tools listed below:
Adjustable Pin Spanner 1
Square Drive Socket Set 1
Metal Ruler (metric) 1
Vise Grip Locking Pliers/Wrench 1
Diagonal Cutting Pliers 1
Multipurpose Flat Nose Pliers 1
Long Nose Pliers 1
Cordless Drill 1
Hammer Drill 1
Hex Key Set (metric) 1
T-Handle Hex Key Set (metric) 1
Combination Wrench Set (metric) 1
Premium Adjustable Wrench 1
High Visibility Urethane Dead Blow Hammer 1
Polymer Replaceable-Face Hammer 1
Engineer's Hammer 1
Scribe 1
Ratchet for a 1/2 in. Drive 1
1-1/8 in. Socket for a 1/2 in. Drive 1
14 mm Hex Socket for a 1/2 in. Drive (May be shipped with system.) 1
19 mm Hex Socket for a 1/2 in. Drive 1
1-1/2 in. Socket for a 1/2 in. Drive 1
1-1/4 in. Socket for a 1/2 in. Drive 1
1-1/4 in. Open-End Wrench 1
Torque Wrench Set 1
Vacuum with Dry Wall Dust Filters and Funnel Tip 1