GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Page 148 Chapter 6 - Table
5.) Refer to Figure 6-47. Reattach the filter wires to the filter.
a.) Attach the black wire to the left side of the filter.
b.) Attach the white wire to the right side of the filter.
Figure 6-47: Filter Connection to (Short) ETC ASM Side of Filter
6.2.6.16 Attach the Ground Wire (P/N 2338084) to the Clutch Driver Unit
The ground wire in the kit may have improperly sized ring terminals, which are too small to fit the
ground hardware. The rings may be cut and spread to fit the hardware. For best results, replace the
terminal with a #10 ring.
1.) Refer to Figure 6-44. Attach one end of ground wire, P/N 2338084, to the ground stud on the
Clutch Driver Box.
2.) Refer to Figure 6-48. Route the ground from the main table harness to the ground bar on the
ETC Power Supply.
Figure 6-48: Attach Ground Wire to Ground Bar
CAUTION Route the ground away from the bottom of the ETC mounting tray to prevent it from catching
when pivoting the ETC tray or fastening the ETC and its cover into place.
3.) Use a 1/8 inch Allen wrench to remove an unoccupied stud on the ground bar.
4.) Fasten the ground wire into place. (Do not tie-wrap at this time.)
Black Wire
White Wire
Attach ground to
unoccupied stud.
To Next Page
Loading...
