GE HEALTHCARE
DIRECTION 2307224-100, REVISION 6DISCOVERY LS SYSTEM SERVICE MANUAL
Page 112 Chapter 6 - Table
6.2 Manual Table
This section contains the instructions to upgrade the secondary base of a manual Discovery patient
table to the automated version.
• The manual (M1) table has a foot pedal to release the secondary base lock and a hand-held
controller to move the secondary base between the PET and CT positions. The secondary
base has metal covers and a window shade roll-up cover.
• The automated table has a new clutch/motor assembly and CT-PET position latching
hardware. The rear and sides of the automated secondary base have new plastic covers
and brackets. A metal roller cover replaces the window shade roll-up cover.
6.2.1 Prerequisites
Complete the following FMIs before starting this upgrade:
• FMI 13590: Turbo SHARC Upgrade
• FMI 13593: DLS 2002 Software Upgrade (supports the automated table base)
CAUTION The DLS 2002 software (FMI 13593) MUST be loaded and fully functional before you upgrade
the table base. Do NOT schedule this upgrade until the DLS 2002 software is loaded and
verified. The table will not function until you install FMI 13593.
6.2.1.1 )Furnished Materials
FMI Kit, P/N 2352689, contains the following BOMs:
• 2354112: DLS Table FMI 13592
• 2344552: Secondary Base Covers - Plastic
• 2330733: Secondary Base Covers HD Collector
• 2352370: Roller Cover Collector
• 2331112: Cover Table - CT Cover Interface
• 2277548: Plug Side Cover H2
• 2371256-100: Discovery LS ME1 to ME1.5 Table Upgrade FMI Instruction
6.2.1.2 Required Tools
In addition to the standard tool kit, the following tools are needed:
• Two large C-clamps
• M4 tap and handle
• M5.5 drill bit
• M4.2 drill bit
• Electric drill
• Cutting oil
• Hacksaw or grinder
To Next Page
Loading...
